Would you mind showing me the configuration file? -Pablo Meneses.
On Thu, Sep 27, 2012 at 12:20 PM, Bill Lake <whl...@gmail.com> wrote: > Agree, > > > That's a known defect. > > The workaround is the following: > > 1) Register the phones to CUCM > 2) Save the configuration "write memory" > 3) Reload the voice gateway > 4) Test SRST again > > That should fix the problem, however, it might come back. > > There is something wrong with the Simple Subnetwork Auto Provisioning > (SNAP) on that IOS version. > On Thu, Sep 27, 2012 at 1:06 PM, Pablo Meneses <pmenese...@gmail.com>wrote: > >> Oh I see, I didn't know that. >> >> But did you have a chance to try the steps I mentioned? >> >> -Pablo Meneses. >> >> On Thu, Sep 27, 2012 at 10:52 AM, Rynard Coetzee < >> rynard.coet...@bytes.co.za> wrote: >> >>> Hi Pablo**** >>> >>> I know what equipment is in the lab ,I have gone for 2 lab attempts. My >>> problem is that I only have Cisco 2911 routers in my home lab ,hence the >>> IOS 15. The SRST in CME mode was setup in a previous lab and it worked fine >>> ,but now it does not seem to work anymore ,I have checked all the configs >>> and everything seems fine ,that is why I posted a question on the forum ,as >>> my question was related to SRST as a technology and not IOS.**** >>> >>> Thanks**** >>> >>> Rynard **** >>> >>> ** ** >>> >>> *From:* Pablo Meneses [mailto:pmenese...@gmail.com] >>> *Sent:* 27 September 2012 06:46 PM >>> *To:* Rynard Coetzee >>> *Cc:* ccie_voice@onlinestudylist.com >>> *Subject:* Re: [OSL | CCIE_Voice] CUCME in SRST mode**** >>> >>> ** ** >>> >>> That's is not the version used on the lab. >>> >>> Check the following link for a full list of equipment and versions: >>> >>> https://learningnetwork.cisco.com/docs/DOC-5292 >>> >>> -Pablo Meneses.**** >>> >>> On Thu, Sep 27, 2012 at 8:36 AM, Rynard Coetzee < >>> rynard.coet...@bytes.co.za> wrote:**** >>> >>> It is ios 15.1 ? >>> >>> Sent from my iPhone**** >>> >>> >>> On 27 Sep 2012, at 2:37 PM, "Pablo Meneses" <pmenese...@gmail.com> >>> wrote:**** >>> >>> That's a known defect. >>> >>> The workaround is the following: >>> >>> 1) Register the phones to CUCM >>> 2) Save the configuration "write memory" >>> 3) Reload the voice gateway >>> 4) Test SRST again >>> >>> That should fix the problem, however, it might come back. >>> >>> There is something wrong with the Simple Subnetwork Auto Provisioning >>> (SNAP) on that IOS version. >>> >>> -Pablo Meneses.**** >>> >>> On Thu, Sep 27, 2012 at 4:13 AM, Rynard Coetzee < >>> rynard.coet...@bytes.co.za> wrote:**** >>> >>> Hi All**** >>> >>> I had this working previously ,but for some reason I just can`t get the >>> phones to push their config to the gw when in srst mode ,only one phone >>> registers without dn and other phone does not even register.**** >>> >>> Below is my config : **** >>> >>> telephony-service**** >>> >>> srst mode auto-provision all**** >>> >>> srst dn template 1**** >>> >>> max-ephones 10**** >>> >>> max-dn 10**** >>> >>> ip source-address 10.10.110.2 port 2000**** >>> >>> time-zone 12**** >>> >>> time-format 24**** >>> >>> date-format dd-mm-yy**** >>> >>> voicemail 914082222500**** >>> >>> max-conferences 8 gain -6**** >>> >>> moh music-on-hold.au**** >>> >>> multicast moh 239.1.1.1 port 16384 route 10.10.201.1 10.10.110.2**** >>> >>> transfer-system full-consult**** >>> >>> secondary-dialtone 9**** >>> >>> create cnf-files version-stamp 7960 Sep 27 2012 06:08:53**** >>> >>> **** >>> >>> Any ideas ?**** >>> >>> Regards**** >>> >>> Rynard**** >>> >>> >>> _______________________________________________ >>> For more information regarding industry leading CCIE Lab training, >>> please visit www.ipexpert.com >>> >>> Are you a CCNP or CCIE and looking for a job? Check out >>> www.PlatinumPlacement.com**** >>> >>> ** ** >>> >>> ** ** >>> >> >> >> _______________________________________________ >> For more information regarding industry leading CCIE Lab training, please >> visit www.ipexpert.com >> >> Are you a CCNP or CCIE and looking for a job? Check out >> www.PlatinumPlacement.com >> > >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com