Craft-O-Matic Adjustable Subscription Cancellation Unit. The unit can be
obtained from most hardware stores and dental clinics.
Be sure to obtain the proper permits to operate the unit from the
Nuclear Regulatory Commission and the Food and Drug Administration in
Washington D.C. USA.
Be sure to carefully unpack the kit and place each component in its
accompanying mesh safety bag.
Mount the Pershing DF4 mesinator on top of the perforated Gerring Mach
77 refibulator and attach them using the eight-millimeter torque fork.
Be sure that the refibulator is mounted at a 66 degree angle and
properly dispersed so that it is flush with the curved section of the
Pyrex thistle tube.
Place the four sections of the triangular separation gear into the
posture cylinder and lock them into place using the band aid adhesive strip.
Insert the wiggling pin into the wobbling hole, making sure that it
seated correctly.
Place the D cell battery and the eleven 9 volt batteries in the power
chamber.
The device should be calibrated before operation using the optional
digital corkscrew accessory pack prior to operation.
Insert the digital corkscrew through the electronic combustion service
chamber using caution not to touch the reinforced tungsten igniter
control module and quickly turn the inverter drive to 28.6 degrees.
Turn the Craft-O-Matic Adjustable Subscription Cancellation Unit upside
down and hit the bottom plate with a 48-ounce ball-peen hammer while
shaking the unit vigorously.
Force open the door to the incineration valve compartment and set the
pressure gauge to 719 psi.
Close the door and seal it shut with duct tape.
The unit should now be properly calibrated and ready to use.
Before activating the Craft-O-Matic Adjustable Subscription
Cancellation Unit, you must first elevate it to a height of 229 feet
above sea level to insure that the unit receives the proper oxygen level
and barometric pressure.
Point the aerial to 17 degrees north by northeast to within the
parameters of the Telstar GS-2 weather satellite and apply pressure to
the wing shaft on the southern most section of the modular accelerator.
Using the special ratchet adapter supplied with the unit, rotate the
heater core to the "on" position. The "on" position has been obtained
when the green light begins to flash, signifying that the red light is
about to go off.
Once the red light is off, flip the toggle switch labeled "ON/OFF" to
the "ON" position and count to 47 before logging on to the system.
Logon using your username and password and wait for the prompt.
Once prompted you must check the box with the appropriate action you
wish to take and then press the pressure release button and turn off the
compressor while turning the hand crank at 231 meters per minute.
Next, press control, alt, delete, caps lock, shift, number lock, escape
and tab simultaneously.
Press enter. You will have one second to complete the procedure.
If you fail to respond in the time limit allowed, simply purchase a new
Craft-O-Matic Adjustable Subscription Cancellation Unit and start from
the beginning.
Please remember that this is the only way we will accept for you to
unsubscribe from this service.
We have made every attempt to simplify the procedure for your
convenience. Failure to comply with the unsubscribe policy will result
in immediate termination of your subscription so please follow the above
directions closely
--
Jeff Fischer
Lake Elmo, MN
'71 Chevelle SS, 454, 4 spd
http://home.attbi.com/~addss/chevelle.html
At 10:42 PM 12/5/2002 -0600, you wrote:
- ----- Original Message -----
- From: John Johnson
- To: [EMAIL PROTECTED]
- Sent: Monday, December 02, 2002 7:03 PM
- Subject: [Chevelle-List] Chevelle List
- How do you get off this list?
