I have a 65 convertible if you need anything more.
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Mike Holleman Sent: Friday, April 11, 2008 8:49 AM To: The Chevelle Mailing List Subject: Re: [Chevelle-list] 1965 Frame & Rearend Larry, I just happen to have a 65 El Camino chassis sitting beside a 65 Malibu chassis. I'll take a few measurements and get back to you later today. Mike Holleman ----- Original Message ----- From: [EMAIL PROTECTED] To: chevelle-list@chevelles.net Sent: Friday, April 11, 2008 5:34 AM Subject: Re: [Chevelle-list] 1965 Frame & Rearend Well I finally broke down and bought a 65 El Camino frame for my project. I looked for a convertible frame for the last 5 years and either they were too far away or too expensive. OK, I know we have been over this about 37 dozen times. I cannot seem to find my information to fit a El Camino frame under my 2 door hardtop. I wrote @ one time that the number was 3.17 inches, but I have seen anywhere from 2 to four inches. I have looked everywhere online and my last resort is to go through all my assembly books. I am not sure if I have the El Camino Length. What I need to know is: 1) The difference in length between the hardtop and El Camino ? 2) Where on the frame to take the length out of ? 3) If you have an answer where did you get it? 4) Galvanize Vs POR 15 vs Powder coat ? 5) Paint my new FAB 9 housing with Hammertite vs POR 15 vs Powder coat ? 6) Frame and housing colors ? 7) Standard Detroit Locker Vs ARB air locker ? Thanks Larry (Z) [EMAIL PROTECTED] 1965 Chevelle Malibu SS Collector of 1965 Chevelle parts Seller of none (got to finish the car first) _____ Planning your summer road trip? Check out AOL <http://travel.aol.com/travel-guide/united-states?ncid=aoltrv00030000000016> Travel Guides. _____ No virus found in this incoming message. Checked by AVG. Version: 7.5.519 / Virus Database: 269.22.11/1368 - Release Date: 4/9/2008 4:20 PM