Thanks for the response.
>From all I read, the TK-760 and the TK-760H are identical except for power
>output. Screenshots from the OEM Kenwood programming software (unfortunately
>DOS only ) also shows the same selection for the TK-760 and 760H. See
>attached.
Of course, I've been selecting TK-760 in Chirp. But, I also tried 760G for
grins.
Thanks Again,
Mike
---- On Wed, 17 Mar 2021 13:41:00 -0500 Jim Unroe <[email protected]> wrote
----
On Wed, Mar 17, 2021 at 2:28 PM Mike Allred <mailto:[email protected]> wrote:
>
> Hello,
>
> New member/user, so apologies if I'm missing something mundane...
>
> I am trying to program a Kenwood TK-760H with Chirp. I am using a Prolific
> USB to 6pin cable that is supposedly designed for this radio (and similar).
>
> When I try to download from the radio it appears to partially work. The
> display on the radio changes to "- PC -" and shows the PC connection icon in
> the top left.
>
> However, after a few seconds I get the error message "Radio refuse to enter
> into program mode after a few tries".
>
> Of course, I never get the configuration from the radio.
>
> Ideas?
>
>
> Thanks,
> Mike
Hi Mike,
According to the Supported Radio Models list on the CHIRP home page,
CHIRP supports Kenwood TK-760 and TK-760G models. There is no mention
of supporting a TK-760H model. I would suspect that CHIRP is unaware
about that particular model's requirements for initiating the cloning
process.
Jim KC9HI
_______________________________________________
chirp_users mailing list
mailto:[email protected]
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to Mike at mailto:[email protected]
To unsubscribe, send an email to
mailto:[email protected]
_______________________________________________
chirp_users mailing list
[email protected]
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to [email protected] at [email protected]
To unsubscribe, send an email to [email protected]
