No, I never have - at least not that I recall. You said that it will
only transmit via the speaker mic ... mine is transmitting a carrier but
there's no modulation. If your experience is similar, I might try
plugging in one of the ones I have. I haven't because I heard reports
that they cause it to stick but there hasn't been a good discussion that
I've seen regarding the symptoms of "sticking".
------ Original Message ------
From "K0LNY_Glenn" <[email protected]>
To "Discussion of CHIRP" <[email protected]>
Date Mon 6 6 22 12:12:58
Subject Re: [chirp_users] What is wrong here?
Did you ever plug in a speaker microphone?
My UV5R is known for sticking inside and it will only transmit the
microphone via the speaker microphone.
I don't want to open it up to try and unstick the contact inside the
jack.
Glenn
----- Original Message -----
From:Al Jones <mailto:[email protected]>
To:Discussion of CHIRP <mailto:[email protected]>
Sent: Monday, June 06, 2022 11:50 AM
Subject: Re: [chirp_users] What is wrong here?
according to Chirp there is nothing set for tone or DTCS on the GMRS
channels (frequencies) lines 31 - 52l the only exception is line 53
where I have a positive offset for the local GMRS repeater.
The problem is that I'm sending a carrier but no voice on the carrier.
Reception is fine all the way 'round,
//al
------ Original Message ------
From "John LaMartina" <[email protected]>
To "Discussion of CHIRP" <[email protected]>
Date Mon 6 6 22 11:10:42
Subject Re: [chirp_users] What is wrong here?
Do you have CTCSS tones set on the receive side.
If so, remove them.
It’s possible the repeaters aren’t sending a tone back
to you..
Stay Safe and Stay Healthy John Miklor
https://www.Miklor.com
On Jun 6, 2022, at 10:01 AM, Al Jones <[email protected]> wrote:
Attached is the image of my 'working' radio - problem
is, it's not working right. This an older Baofeng UV-82L much prior to the
recent FCC rule changes. I am both a licensed ham (KG5HEJ) and GMRS
(WQYM836) operator. Though I recognize the legalities of using this radio,
it's use in the GMRS bands is primarily for monitoring local tourists and
providing them with help.
That all out of the way. RX/TX on any of the ham bands
is without problem, I can talk with anyone on our local repeater system, or
simplex, without a problem (barring mountains which are occasional problems)
on the GMRS freqs, I'm seeing (on my BCT15X scanner) a carrier being
transmitted in the appropriate freq but hearing no voice on the carrier on
both the one GMRS repeater channel and simplex. I and a friend have been all
over these settings and I hope we're just missing the obvious (obvious to
someone else.)
Anyone ???
//al KG5HEJ
--------------------------------------------------------------------------------
_______________________________________________
chirp_users mailing list
[email protected]
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to K0LNY at [email protected]
To unsubscribe, send an email to
[email protected]
To report this email as off-topic, please email
[email protected]
_______________________________________________
chirp_users mailing list
[email protected]
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to [email protected] at [email protected]
To unsubscribe, send an email to [email protected]
To report this email as off-topic, please email
[email protected]
