-----Original Message----- From: Jose [mailto:[EMAIL PROTECTED] Sent: Tuesday, April 01, 2008 6:02 PM To: Lasher, Donn Cc: Cisco; Gerald Krause Subject: Re: [c-nsp] NPE-G1 support for jumbo frames
>Donn, what version of code were you using? This is pretty scary >considering that one of the factors of going to NPE-G1 is hoping to take >advantage of jumbo frame or at least 1530 on the three ports. This behavior occurred under every code revision we tested on the NPE-G2's, which was, 12.4.11T, and 12.2.3x-SB trains. It worked fine on the PA-FE-TX cards under the same train, just not on the onboard ports. Again, once the port is forced to 1000, either fiber or copper, any MTU up to 9216 wasn't a problem (assuming your switch can handle it). Forced at 100 however, it wouldn't exceed 1500+overhead, which breaks 1500 unfragged inside an MPLS VPN. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
