Hi there, I've seen this a few times in the past and its always been chalked up to a line or upstream issue but a couple of times I've noticed that if I do a ping ip with say 1000 repeats of size 100 I'll hit maybe 60% loss on circuits which have BGP neighbors, but if I shutdown the BGP neighbor and repeat the "test" the circuit is "clean". I am trying to find a 'definitive' way to determine whether or not the issue is that:
A) When I shutdown BGP the traffic on the line dropped to a level in which the circuit or the "device" on the other end could actually handle it. B) My Router/Line card could handle sending the ICMP because I shut down the BGP session on the circuit. The circuit sizes have ranged from a POS (622Mbps) and a Gig-E So two different types of line cards (this is a GSR) so I did a 'show ip cef resources' and its all 'G' so I assume that means I am not pushing the line cards too hard. I'm assuming the issue is A but I'd like a way to really know for certain, any thoughts? -Drew _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
