Just ran into a similar problem with 15.2(4)S2 and 15.3(1)S -can't even ping the other end of the link -funny is that bgp session works on the CE-PE ip addresses. So routing vise everything works just fine I just can't pass any data.
However this problem started only when I enabled ipv6 in addition to the ipv4 setup. Debug ip packets for the CE to PE ping shows that the PE got the icmp and replied back. Though the ACL in OUT direction on the PE side did not catch any outgoing icmp traffic and neither the CE received any. adam -----Original Message----- From: cisco-nsp [mailto:cisco-nsp-boun...@puck.nether.net] On Behalf Of Aivars Sent: Friday, May 10, 2013 10:39 AM To: cisco-nsp Subject: [c-nsp] ME3600x L3VPN MPLS problems with 15.3.2S I tried to deploy Me3600x as MPLS PE with IOS 15.3.2S and failed. It is a straight forward MPLS L3VPN configuration with OSPF in the core and static routes between PE - CE. With 15.3 I was not able to ping even a directly connected CE IP from another PE (7600) in the network. I was able however ping IP on ME3600 from the same PE - CE subnet. All routes and labels seem to be fine on both PEs and P as well. I was able however ping IP on ME3600 from the same PE - CE subnet. The exact same configuration on the same switch works fine with 15.2S. Just saved config, rebooted with 15.2 and the ping to the CE direct IP and statically routed subnet was fine. I was able to replicate the same behavior using a test ME3600 connected to MPLS core. Has anybody seen something like this? I am not able to find any similar bug in the bug toolkit. Aivars _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
