I have seen this on a bunch of different ME3600s across my network from 15.2 all the way up to and including 15.3. I haven't actually been able to readily duplicate this, so I'm very intrigued that you both are able to replicate it, seemingly at will.
I actually have a call scheduled at 11am with a fleet of Dev engineers from India and SJ. I will be bringing this up with them, because this is one of our big mystery issues that we can't replicate but have seen multiple times. Can either of you share a *complete* device config? (Passwords, SNMP comma and IPs sanitized, if required). I'd be grateful and hopefully with your help we'll be able to put a bugid to this issue. Thanks. -- Sent from my mobile device On 2013-05-10, at 7:26 AM, Adam Vitkovsky <adam.vitkov...@swan.sk> wrote: > Just ran into a similar problem with 15.2(4)S2 and 15.3(1)S -can't even ping > the other end of the link -funny is that bgp session works on the CE-PE ip > addresses. > So routing vise everything works just fine I just can't pass any data. > > However this problem started only when I enabled ipv6 in addition to the > ipv4 setup. > > Debug ip packets for the CE to PE ping shows that the PE got the icmp and > replied back. > Though the ACL in OUT direction on the PE side did not catch any outgoing > icmp traffic and neither the CE received any. > > > adam > -----Original Message----- > From: cisco-nsp [mailto:cisco-nsp-boun...@puck.nether.net] On Behalf Of > Aivars > Sent: Friday, May 10, 2013 10:39 AM > To: cisco-nsp > Subject: [c-nsp] ME3600x L3VPN MPLS problems with 15.3.2S > > I tried to deploy Me3600x as MPLS PE with IOS 15.3.2S and failed. It is a > straight forward MPLS L3VPN configuration with OSPF in the core and static > routes between PE - CE. With 15.3 I was not able to ping even a directly > connected CE IP from another PE (7600) in the network. > I was able however ping IP on ME3600 from the same PE - CE subnet. All > routes and labels seem to be fine on both PEs and P as well. I was able > however ping IP on ME3600 from the same PE - CE subnet. The exact same > configuration on the same switch works fine with 15.2S. Just saved config, > rebooted with 15.2 and the ping to the CE direct IP and statically routed > subnet was fine. I was able to replicate the same behavior using a test > ME3600 connected to MPLS core. > > Has anybody seen something like this? I am not able to find any similar bug > in the bug toolkit. > > Aivars > > > _______________________________________________ > cisco-nsp mailing list cisco-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > > _______________________________________________ > cisco-nsp mailing list cisco-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/