On 28/06/2013 17:55, "Rolf Hanßen" wrote: > does not look like this is a general hardware version issue.
mmm, ok. I would: - run a context diff on the configuration on each of these machines to ensure that there are no syntactic differences - disable and then re-enable copp on the affected box to ensure that it's reprogrammed correctly into the hardware (sometimes things get messed up on the way down to the line cards) - compare the output of "show mls rate-limit" on all machines - check your platform acl tcam capacity using "show platform hardware capacity acl", to ensure that you still have some acl tcam space available for your copp config. If this doesn't point towards a resolution, I'd open up a tac case. Nick > But I found a box with the same hardware versions: > > Mod Port Model Serial # Versions > ---- ---- ------------------ ----------- > ------------------------------------- > 5 2 WS-SUP720-3B ########### Hw : 5.3 > Fw : 8.4(2) > Sw : 12.2(33)SXJ > Sw1: 20.1(1)SXJ > WS-SUP720 ########### Hw : 2.6 > Fw : 12.2(17r)SX7 > Sw : 12.2(33)SXJ > WS-F6K-PFC3B ########### Hw : 2.3 > > This box also works as soon as I enter "mls rate-limit unicast cef glean > 500". > > kind regards > Rolf > >>> Any further ideas except hardware failure, buggy software or "try >>> rebooting it" ? >> >> Could be a hardware issue. As someone else mentioned (Phil?), this >> particular feature is hardware revision dependent. >> >> What hardware versions are each of your SUP720s (show module)? >> >> Nick >> >> >> > > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
