Ipv6 address autoconfig default Injects a default route as well.
Jey S. Network Engineer CCIE #41608 Sent from my iPhone > On 4 Jan 2014, at 22:33, Nick Hilliard <[email protected]> wrote: > >> On 04/01/2014 22:13, M K wrote: >> HiYes , It's clear for me now , can you provide how to set the managed >> bit in the RA messages? > > int Foo1/1 > ipv6 nd managed-config-flag > ipv6 nd other-config-flag > >> On 04/01/2014 22:18, Jeyamurali Sivapathasundaram wrote: >> RA is enabled by default unless you configure >> IPV6 ND RA suppress > > You can't do that because there is no option in dhcpv6 to provide a default > route. So in order to use DHCPv6, you need to leave RA enabled to provide > default route only, then set the M+O flags in RA packets to hand over to > DHCPv6, then turn off absolutely everything else in RA including stuff > which is enabled by default like prefix announcements. > > Nick > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
