Thanks a stack Joe
I tried all of that and I am now sure I have a doorstopper/paper weight .
I remove the card & reseat it and it shows the extract/insert , status red
light, status lights green , status lights orange & then shows that the card
FAILS .
Nice when that card has to go into a campus implementation this coming
weekend !
Cheers
Olden
-----Original Message-----
From: Joe Pinkus [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, July 18, 2000 2:02 PM
To: Olden Pieterse
Cc: '[EMAIL PROTECTED]'
Subject: Re: Cisco6509 with dead modules
Olden,
A couple of things to try before opening a TAC case:
1. show modules, is the module recognized
2. show test <mod#>, what are the results, any failures
3. reseat the module, what are the console messages during this reseat
4. if all are still failures, verfiry a different slot in the chasis
Joe
Olden Pieterse wrote:
> Hi there
>
> Just quickly a question : I have a 6509 with a 48port ethernet card in it
.
> On the front the status lights are orange
> If I do a show module x , then I get a status==other , all the rest are
ok
> .
> I have enabled the module , put the power on and the works !
>
> Is there anything else I can do to revive this module or can I safely
assume
> its going to be good as a door stopper/paper weight ?
>
> Cheers
>
> Olden Pieterse
> MCP , CCNA , BCMSN , BSCN , BCRAN
> Brainbench Certified CISCO Network Implementation Specialist
> Technical Consultant
> Mobile : +27 82 410 8621
>
> ___________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
