You must run 12.0(7)XK1 for the 1fe2w to be supported.
Brian
On Wed, 26 Jul 2000, Provost, Rob wrote:
> I have two new 3600 with IOS 11.2 installed. I installed the 1 Fast
> Ethernet/2 Wan slot network module and a WIC 1T in the module. On boot up
> I get the error:
>
> %PA-2-UNDEFPA: Undefined Port Adaptor type 0 in bay 0
> %LINK-4-NOMAC: A random default MAC address of 0000.0c82.e75a has
> been chosen. Ensure that this address is unique, or specify MAC
> addresses for commands (such as 'novell routing') that allow the
> use of this address as a default.
>
> Here is the info I received from the TAC troubleshooting web site:
>
> Error Message
> %PA-2-UNDEFPA: Undefined Port Adapter type [dec] in bay [dec]
> Explanation The software does not have a driver for the port adapter type
> located in the specified bay.
> Recommended Action Ensure that the image you are running supports this card.
> Check that the card is properly seated. If the message recurs, copy the
> error message exactly as it appears on the console or in the system log,
> call your Cisco technical support representative and provide the
> representative with the gathered information.
> I reseated the cards, with no change. I have the IP/IPX feature pack IOS
> 12.0.7 to install. I assume that IOS 12.0.7 will support the network
> module. How can I upgrade the IOS since the system doesn't recognizing the
> Ethernet port?
>
> Thanks in advance,
>
> Robert Provost
>
>
--
-----------------------------------------------------
Brian Feeny, CCNA [EMAIL PROTECTED]
318-222-2638 x 109 http://www.shreve.net/~signal
Network Administrator ShreveNet Inc. (ASN 11881)
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]