That would depend on the size of your network and the switches you use.
We are running an all switched network for everything from desktops to
servers. Of course we aren't using Cisco (gasp) which brings the cost down.
100 + nodes, 5 24 port l2 switches 2 8 port L3 switches.
----- Original Message -----
From: "Mooney Drew-DMOONEY1" <[EMAIL PROTECTED]>
To: "'Marc Quibell'" <[EMAIL PROTECTED]>; "Drew Mooney-DMOONEY1"
<[EMAIL PROTECTED]>; <[EMAIL PROTECTED]>
Sent: Thursday, July 27, 2000 9:20 PM
Subject: RE: CCDA question-512 bit times
> -----Original Message-----
> From: Marc Quibell [mailto:[EMAIL PROTECTED]]
> Sent: Thursday, July 27, 2000 5:41 PM
> To: Drew Mooney-DMOONEY1; [EMAIL PROTECTED]
> Subject: RE: CCDA question-512 bit times
>
>
>
> The ideal network is a completely switched network, no hubs. No collisions
> in full-duplex mode.
>
> *** Expensive solution though, yes? Any hard and fast rules concerning
when
> this level of service becomes justifiable?
>
> I could see providing a dedicated switch port to servers. Perhaps even
> to a few power-users on a network - but to provide a dedicated port to
> ALL users and network devices [eg printers/plotters] would cost a
> fortune
> in cabling & switches.
>
> ___________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
