FWIW, here is a current working config, 3640 to a Kentrox.  If you 
have the cable connected and the CSU powered you should get an up/down 
state.

interface Hssi3/0
  description to Qwest xxxxx
  ip address x.x.x.x 255.255.255.252
  encapsulation ppp
  load-interval 30
  serial restart-delay 0

   Dave

Jablonski, Michael wrote:
> Has anyone had any experience w/the following combination?
> 
> 3640 & NM-1HSSI & Kentrox DataSMART T3/E3 IDSU
> 
> I've been trying, to no avail, to bring the HSSI up for a 12M DS3....  The
> CSU/DSU, according to the lights, is ready to send and receive data; but
> when I bring up the int on the router, it shows down down.  Here's the
> router info:
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~
> interface Hssi1/0
>  bandwidth 12000
>  ip address x.x.x.x 255.255.255.252
>  serial restart_delay 0
>  no cdp enable
> 
> Hssi1/0 is down, line protocol is down
>   Hardware is M1T-HSSI-B
>   Internet address is x.x.x.x/30
>   MTU 4470 bytes, BW 12000 Kbit, DLY 200 usec,
>      reliability 255/255, txload 1/255, rxload 1/255
>   Encapsulation HDLC, crc 16, loopback not set
>   Keepalive set (10 sec)
>   Restart-Delay is 0 secs
>   Last input never, output never, output hang never
>   Last clearing of "show interface" counters never
>   Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
>   Queueing strategy: fifo
>   Output queue :0/40 (size/max)
>   5 minute input rate 0 bits/sec, 0 packets/sec
>   5 minute output rate 0 bits/sec, 0 packets/sec
>      0 packets input, 0 bytes, 0 no buffer
>      Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
>               0 parity
>      0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
>      0 packets output, 0 bytes, 0 underruns
>      0 output errors, 0 applique, 8 interface resets
>      0 output buffer failures, 0 output buffers swapped out
>      13 carrier transitions     LC=down  CA=down  TM=down LB=down TA=up
> LA=down
-- 
David Madland
CCIE# 2016
Sr. Network Engineer
Qwest Communications
612-664-3367

"Government can do something for the people only in proportion as it
can do something to the people." -- Thomas Jefferson




Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=73169&t=73129
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]

Reply via email to