You have to partition the Flash to make it one big (virtual) flash.
Check out :
http://www.cisco.com/univercd/cc/td/doc/product/software/ios112/112cg_cr/1cb
ook/1csysim.htm#xtocid2402062
(watch the word wrap)
Bob
----- Original Message -----
From: "Ashfaq Aslam" <[EMAIL PROTECTED]>
Newsgroups: groupstudy.cisco
To: <[EMAIL PROTECTED]>
Sent: Friday, September 01, 2000 4:54 PM
Subject: Memory question - pls help !!
> Hi there,
>
> I have just installed 2 X 8MB Flash modules in 2503 Router and when I do
> "Show Version" it shows up as two seperate 8MB Flashes instead of 16MB.
> E.g.
>
> cisco 2500 (68030) processor (revision F) with 16384K/2048K bytes of
> memory.
> Processor board ID 04594752, with hardware revision 00000000
> Bridging software.
> X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
> Basic Rate ISDN software, Version 1.0.
> 1 Ethernet/IEEE 802.3 interface.
> 2 Serial network interfaces.
> 1 ISDN Basic Rate interface.
> 32K bytes of non-volatile configuration memory.
> 8192K bytes of processor board System flash partition 1 (Read/Write)
> <<***************???***
> 8192K bytes of processor board System flash partition 2 (Read/Write)
> <<***************???***
>
> Configuration register is 0x2142
>
> Router#
>
> Does anyone know how to make it come up as 16MB?
>
> Thanks for your help !!!
>
> Rgds,
> Ash
>
> ___________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
