EIGRP metric looks at bandwidth, delay, mtu, load, reliability.
For an adjaceny to form they metrics must be the same on both sides, or the
2 routers will never route or pass updates.
Best to make the same changes on both sides. As for the clock rate, I am not
to sure here - a flying guess says yes
Regards
Andrew
-----Original Message-----
From: SV [mailto:[EMAIL PROTECTED]]
Sent: 07 September 2000 17:25
To: [EMAIL PROTECTED]
Subject: EIGRP metric
Hi friends
I am reading up on EIGRP and have some questions
My scenario is simple; two routers connected by a DCE/DTE crossover cables.
1) Does the clock rate set on the DCE interface effect the EIGRP metric in
any way.
2) If suppose I change the bandwidth and the delay of the interface on
Router 1 from the default values, should I have to change it on the router
R2 too.
Thanks
SV
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associate-Announcement.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
