Also, don't forget to ensure that PVC switching is configured correctly on
the LS1010;
Something like this on each LS1010 interface that the routers are connected
to.
atm-pvc 44 102 interface atm 1/1/1 200
This is the same thing you did with the frame relay route command.
HTH,
Charles
""sdonoho"" <[EMAIL PROTECTED]> wrote in message
015101c027fb$774bba20$[EMAIL PROTECTED]">news:015101c027fb$774bba20$[EMAIL PROTECTED]...
> Kevin,
> Not sure with out seeing your config but try mapping the destination
> address of the PVC:
>
> int ATM2/1
> ip address 220.1.1.1 255.255.255.0
> atm pvc 10 0 32 aal5snap
> map-group trythis
> !
> map-list trythis
> ip 220.1.1.2 atm-vc 10
>
>
> -Scott
>
> > -----Original Message-----
> > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
> > Kevin Wigle
> > Sent: Tuesday, September 26, 2000 11:01 AM
> > To: cisco
> > Subject: ATM Config
> >
> >
> > and while I'm asking........
> >
> > getting lots of use out of the lab here..........
> >
> > I've got 3 4700/4500s with an ATM interface, a 7505 with ATM and
> > an LS-1010.
> >
> > Using a config from Hutnick, I can't seem to get connectivity.
> >
> > On page 287 for the cmd "sh atm vc", Status is shown as "ACTIVE".
> >
> > I only see "UP". Also, I can't ping from one ATM router to the other.
> >
> > On the LS-1010, I see "UpAndNormal" for the ILMI state and "Idle" for
the
> > SSCOP state.
> >
> > Sitting on any router, (telnet in) I cannot ping the ATM
> > interface of that
> > router, but I can ping any other address on the router as well as stuff
on
> > the lab network.
> >
> > Any thoughts? No special config here, bare bones just trying to get
from
> > router to router over ATM.
> >
> > tia
> >
> > Kevin Wigle
> >
> >
> > **NOTE: New CCNA/CCDA List has been formed. For more information go to
> > http://www.groupstudy.com/list/Associates.html
> > _________________________________
> > UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> > FAQ, list archives, and subscription info: http://www.groupstudy.com
> > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> >
>
> **NOTE: New CCNA/CCDA List has been formed. For more information go to
> http://www.groupstudy.com/list/Associates.html
> _________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
