Tom,
Try these steps, I think
Boot the router in boot mode.
Enable and enter configuration mode
Issue "no partition flash" (or "no flash partition" - I think that it was
the first one).
Write the config change to memory.
Reload the router (still in boot mode).
Once this has been done I think that you will see a single flash partition.
Regards,
Nathan
-----Original Message-----
From: Tom Pruneau [mailto:[EMAIL PROTECTED]]
Sent: Monday, January 14, 1980 6:08 PM
To: [EMAIL PROTECTED]
Subject: 2511 Flash Memory Question
Greetings All
I have a 2511 with 4 MB of flash in it. I need to upgrade the IOS needs
7MB. I tried canabalizing another 2511 I had and adding it's 4MB to the 1st
routers 4MB making what I believed to be 8MB. But when I tried to tftp the
new image over I still got an error saying not enough memory, and yes I had
opted to erase the flash first. When I went and looked at the flash the
router saw it as two 4MB cards instead of 1 8MB.
What do I need to do to get the flash blended together to act as 1 8MB?
Thanks
Tom
Tom Pruneau
Trainer Network Operations
GENUITY
3 Van de Graff Drive Burlington Ma. 01803
24 Hr. Network Operations Center 800-436-8489
If you need to get a hold of me my hours are 7AM-3PM ET Mon-Fri
---------------------------------------------------------------------------
This email is composed of 82% post consumer recycled data bits
---------------------------------------------------------------------------
"Once in a while you get shown the light
in the strangest of places if you look at it right"
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
