I am trying to set up a modem to dial into the AUX port of a Cisco2610
router for remote support. I am using HyperTerminal on the PC and I have
set up a reverse telnet session into the modem (3 Com U.S Robotics � 56K fax
modem) connected to the AUX port. The modems seem to connect correctly but
I am unable to see EXEC mode on the router. While connected I can send
text from the HyperTerminal to the reverse telnet session into the router �
BUT I can not see EXEC mode on the router. I have tried different routers
and about 3 different modems (along with numerous AT strings) � but no
success. After the two modems have connected, I get the following message
on HyperTerminal
CONNECT 28800/V42BIS
That�s about it! Any text I type into the HyperTerminal can be see on the
reverse telnet session and vice versa.
The router config is below:
hostname Router
!
ip subnet-zero
ip host aux 2065 1.1.1.1
!
interface Loopback0
ip address 1.1.1.1 255.255.255.255
!
interface Ethernet0/0
no ip address
shutdown
!
interface Serial0/0
no ip address
shutdown
!
!
line con 0
transport input none
line aux 0
password cisco
login
modem Dialin
modem autoconfigure type usr_sportster
transport input all
stopbits 1
speed 115200
flowcontrol hardware
line vty 0 4
login
!
no scheduler allocate
end
Has any one else out there experienced the same problem - I am missing
something?
Any help would be much appreciated.
Cheers,
Suzi
_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
Share information about yourself, create your own public profile at
http://profiles.msn.com.
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
