hi ;
do u need the
3 routers to be in the same subnet ?? if so ...gateway of last resort will not
work since there is a more specific route directly connected , i guess u
have to check then something like policy routing .
as u didnt
mention that it is a must to put the routers in the same subnet , then creating
two different subnets ( one between r1 subif1 and r2 and the second
between r1subif2 and r3 ) will simply solve your problem
Mohamed A.Heeba
CCNP ,CCDA-----Original Message-----In a message dated 11/27/00 12:46:17 AM Eastern Standard Time,
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
Sent: Sunday, November 26, 2000 10:56 PM
To: [EMAIL PROTECTED]; [EMAIL PROTECTED]
Subject: Re: Frame Relay Problem
[EMAIL PROTECTED] writes:
Solve the problem with routing, not
layer 3 to layer 2 mapping".
Hence ruling out any static frame mapping or arp type solutions as these
are all layer 2 to layer 3 mapping techniques.
Couldn't you use, on the edges (r2/r3), a gateway of last resort like (ip
route 0.0.0.0 0.0.0.0 s0) so when you couldn't find a route it would send it
out s0 to the frame switch and then r1 would be able to pass it to the other
end...?
Another thought. The lab says that it doesn't want you to use layer 3 to
layer 2 mapping. Why can't you use static if it's, as you said, layer 2 to
layer 3?
These are just some thoughts, hope I spark something...
Mark Zabludovsky ~ CCNA, CCDA, 1/2-NP
[EMAIL PROTECTED]
"Even if I knew I had only 1 more week to live, I would still schedule
my CCIE lab. I would just have to work a little harder I guess. After all,
without any goals in life, I'm dead already."
~Mark Zabludovsky~
