Ok, I got a 4500 and 4700 sitting here. I gave the commands as listed and I got the same warning/error. However, I noticed that in the running-config that the command was there. I then tried to tftp from one to the other and it worked. Kevin Wigle ----- Original Message ----- From: "Pierre-Alex" <[EMAIL PROTECTED]> To: "Andy Walden" <[EMAIL PROTECTED]>; "ItsMe" <[EMAIL PROTECTED]> Cc: <[EMAIL PROTECTED]> Sent: Monday, 11 December, 2000 09:39 Subject: RE: TFTP > I have two routers. A Cisco 4000 (the TFTP server) and a Cisco2513 (the > client) This is what I did and what I got. What went wrong? > > > Cisco4000(config)#tftp-server flash:c2500-js-l_112-17.bin > Warning: flash:c2500-js-l_112-17.bin does not exist. Command retained > > > Cisco2513#copy flash tftp > > System flash directory: > File Length Name/status > 1 8108960 c2500-js-l_112-17.bin > [8109024 bytes used, 279584 available, 8388608 total] > Address or name of remote host [192.168.0.1]? > Source file name? c2500-js-l_112-17.bin > Destination file name [c2500-js-l_112-17.bin]? > Verifying checksum for 'c2500-js-l_112-17.bin' (file # 1)... OK > Copy 'c2500-js-l_112-17.bin' from Flash to server > as 'c2500-js-l_112-17.bin'? [yes/no]yes > .. > TFTP: error code 2 received - Access denied > > THANKS > > Pierre-Alex > > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of > Andy Walden > Sent: Sunday, December 10, 2000 5:55 PM > To: ItsMe > Cc: [EMAIL PROTECTED] > Subject: Re: TFTP > > > > Did you bother checking before you have that answer? > > You can configure the network server to act as a limited Trivial File > Transfer Protocol (TFTP) server from which other Cisco servers can boot > their software. As a TFTP server host, the network server responds to TFTP > read request messages by sending a copy of its ROM software to the > requesting host. The TFTP read request message must use the file name that > you specified in the network server configuration. > > To specify TFTP server operation for a communications server, use the > tftp-server system global configuration command. The full syntax follows. > > tftp-server system filename list > no tftp-server system filename list > This command has two arguments: filename and list. The argument filename > is the name you give the communications server ROM file, and the argument > list is an IP access-list number. > > The system sends a copy of the ROM software to any host which issues a > TFTP read request with this file name. To learn how to specify an access > list, see the "Configuring IP Access Lists" section in the chapter > "Routing IP." > > You can specify multiple file names by repeating the tftp-server system > command. To remove a previously defined file name, use the no tftp-server > system command and append the appropriate file name and an access-list > number. > > Images that run from ROM, including IGS images, cannot be loaded over the > network. Therefore, it does not make sense to use TFTP to offer the ROMs > on these images. > > Example: > This command causes the router to send, via TFTP, a copy of the ROM > software when it receives a TFTP read request for the file configfile. The > requesting host is checked against access list 22. > > tftp-server system configfile 22 > > > > On Sun, 10 Dec 2000, ItsMe wrote: > > > Hmmm, the way I read your request - a router as a tftp server, to my > > knowledge you, can't. > > You need another box for the server itself? > > > > ""Pierre-Alex"" <[EMAIL PROTECTED]> wrote in message > > [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > > > Hi Group, > > > > > > How do you setup a router as a TFTP server? > > > > > > Which routers support that feature? > > > > > > Thanks > > > > > > Pierre-Alex > > > > > > _________________________________ > > > FAQ, list archives, and subscription info: > > http://www.groupstudy.com/list/cisco.html > > > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED] > > > > > > > > > _________________________________ > > FAQ, list archives, and subscription info: > http://www.groupstudy.com/list/cisco.html > > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED] > > > > _________________________________ > FAQ, list archives, and subscription info: > http://www.groupstudy.com/list/cisco.html > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED] > > _________________________________ > FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED] > _________________________________ FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
