Hubert
The source-bridge ring-group is not necessary in an ethernet environment.
It has no effect in your configuration. You must check locally at each
router if you can see the local PU´s mac-address or netbios-name. If this
is working, you can try with a DEBUG DLSW CIRCUITS and DEBUG DLSW PEER to
verify why the circuit is not stablished . Otherwise, if you can not see the
mac or netbios name locally, you have a problem with your PU´s and you
cannot see any debug activity.
Please tell me if I can help you.
Regards
Juan Carlos Ameneiro
-----Original Message-----
From: Hubert Pun [mailto:[EMAIL PROTECTED]]
Sent: Martes 12 de Diciembre de 2000 00:18 AM
To: Cisco Study Group
Subject: DLSw help
Here is the config between two router with Ethernet interfaces for
DLSw. (The other site is just a mirror image).
When I perform a "show dlsw peer", the state is CONNECT
However, "sh dlsw reachability " and "show dlsw circuits " is empty.
Also, "show dlsw capabilities " has " reachable mac addresses : none"
All the interfaces on the network has connectivity to each other, and
there is no access list.
Thanks in advanced
===============================================
source-bridge ring-group 1234
dlsw local-peer peer-id 137.20.103.2
dlsw remote-peer 0 tcp 137.20.100.1
dlsw bridge-group 1
int e0
ip address 137.20.40.1 255.255.255.0
bridge-group 1
no shut
bridge 1 protocol ieee
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
