The dlsw circuits is empty because nobody is trying to connect to
an SNA server.
The dlsw reachability is something that makes me fill unhappy.
You should see the MAC address of your AS/400 or any other SNA server
Added to that you should see the mac address of the WIN95,WIN98 PC's that
is using NETBios.
Hope this help
Regards
Elias Aggelidis
CCNP + Voice
----- Original Message -----
From: "Hubert Pun" <[EMAIL PROTECTED]>
To: "Cisco Study Group" <[EMAIL PROTECTED]>
Sent: Tuesday, December 12, 2000 5:17 AM
Subject: DLSw help
> Here is the config between two router with Ethernet interfaces for
> DLSw. (The other site is just a mirror image).
>
> When I perform a "show dlsw peer", the state is CONNECT
> However, "sh dlsw reachability " and "show dlsw circuits " is empty.
> Also, "show dlsw capabilities " has " reachable mac addresses : none"
>
> All the interfaces on the network has connectivity to each other, and
> there is no access list.
>
> Thanks in advanced
>
>
> ===============================================
> source-bridge ring-group 1234
> dlsw local-peer peer-id 137.20.103.2
> dlsw remote-peer 0 tcp 137.20.100.1
> dlsw bridge-group 1
>
> int e0
> ip address 137.20.40.1 255.255.255.0
> bridge-group 1
> no shut
> bridge 1 protocol ieee
>
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
