Help,
I have a 3600 @ 11.3 which is running as a frame switch on some ports
and I am trying to configure some of the other ports as routed
point-to-point sub-ints.
But when configuring the second sub int I get the following.
frsw1(config)#int s0/0.1 point-to-point
frsw1(config-subif)#exit
frsw1(config)#int s0/0.2 point-to-point
% Warning: cannot change link type
Which results in the following configuration
interface Serial0/0
no ip address
no ip mroute-cache
encapsulation frame-relay
!
interface Serial0/0.1 point-to-point
no arp frame-relay
!
interface Serial0/0.2 multipoint
no arp frame-relay
Any ideas?
Les
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
