That's correct. The only two commands that you have to reload a router, are
when changing the ISDN switch type and changing subinterfaces from
point-to-point to point-to-multipoint or vice versa. At least the only two
that I've heard of. I'd be interested if someone has heard of any others.
--Mike
-----Original Message-----
From: Maccubbin, Duncan
To: [EMAIL PROTECTED]
Sent: 12/13/00 7:47 AM
Subject: RE: % Warning: cannot change link type
then tried to delete it and bring it back up as a point-to-point. You
will
get this error with 11.x IOS. Delete the interface and restart the
router.
That should enable you to change the frame type to multipoint.
Good luck,
Duncan
-----Original Message-----
From: les flack [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, December 13, 2000 8:56 AM
To: [EMAIL PROTECTED]
Subject: % Warning: cannot change link type
Help,
I have a 3600 @ 11.3 which is running as a frame switch on some ports
and I am trying to configure some of the other ports as routed
point-to-point sub-ints.
But when configuring the second sub int I get the following.
frsw1(config)#int s0/0.1 point-to-point
frsw1(config-subif)#exit
frsw1(config)#int s0/0.2 point-to-point
% Warning: cannot change link type
Which results in the following configuration
interface Serial0/0
no ip address
no ip mroute-cache
encapsulation frame-relay
!
interface Serial0/0.1 point-to-point
no arp frame-relay
!
interface Serial0/0.2 multipoint
no arp frame-relay
Any ideas?
Les
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]