You can't change a subinterface from one type to another without rebooting.
In this case, you already have it configured as multipoint. Either use
another subinterface or remove this one and reboot.
HTH,
John
> Help,
>
> I have a 3600 @ 11.3 which is running as a frame switch on some ports
> and I am trying to configure some of the other ports as routed
> point-to-point sub-ints.
>
> But when configuring the second sub int I get the following.
>
> frsw1(config)#int s0/0.1 point-to-point
> frsw1(config-subif)#exit
> frsw1(config)#int s0/0.2 point-to-point
> % Warning: cannot change link type
>
> Which results in the following configuration
>
> interface Serial0/0
> no ip address
> no ip mroute-cache
> encapsulation frame-relay
> !
> interface Serial0/0.1 point-to-point
> no arp frame-relay
> !
> interface Serial0/0.2 multipoint
> no arp frame-relay
>
> Any ideas?
>
> Les
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_______________________________________________________
Send a cool gift with your E-Card
http://www.bluemountain.com/giftcenter/
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]