I'm having trouble configuring one router was wondering if you could help
We are configuring a 5500 Chassis with:
> >
> > 1) WS X5530 Supervisor Engine (Slot 1)
> > 2) WS X5302 Route Switch Module (Slot 2)
> > 3) WS 5224 Switch ports (24 copper ports)
> >
> > A)
> > We have defined:
> > VLAN 100 on 3/1-4
> > VLAN 200 on 3/5-8
> > VLAN 300 on 3/9-12
> > VLAN 500 on 3/21-24
> > B)
> > We have created the interfaces on the RSM:
> > Config Terminal:
> > 1) Interface vlan 100
> > ip address 192.170.1.1 255.255.255.0
> > 2) Interface vlan 200
> > ip address 192.170.2.1 255.255.255.0
> > 3) Interface vlan 300
> > ip address 192.170.3.1 255.255.255.0
> > 5) Interface vlan 500
> > ip address 192.170.5.1 255.255.255.0
> >
> > Performed a no shutdown command on all interfaces.
> >
> > C)
> > We implemented "eigrp 1" as the routing protocol using:
> > Interface vlan 100
> > router eigrp 1
> > network 192.170.1.0
> > network 192.170.2.0
> > network 192.170.3.0
> > network 192.170.5.0
> > The above was repeated for all vlans (100,200,300,500)
> > D)
> > 1) Can not ping any vlan interfaces.
> > 2) Performed a "Show Interface" and it shows all interfaces are down.
> >
> >
> > Thanks for looking into this and we appreciate any insight on this
> > problem.
> >
> Craig.
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
