On a 650x, from the switch, if you issue the set msmautostate to disable,
this should prevent you from having to have a device active on each VLAN.
I've done this with having an MSFC installed, and it seems to work.
On the 5500, I think the command is set rsmautostate disable, but I'm not
sure if it will work... give it a whirl...
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
Brian Gleason
Sent: Wednesday, December 20, 2000 10:53 AM
To: [EMAIL PROTECTED]
Subject: Re: problems configuring a 5500 chasis please help
Try plugging in a client machine into each of your vlans. I had this
problem with a 6509 and once the client link state came up, the interface
came up.
""viathin"" <[EMAIL PROTECTED]> wrote in message
91plqc$2ti$[EMAIL PROTECTED]">news:91plqc$2ti$[EMAIL PROTECTED]...
> I'm having trouble configuring one router was wondering if you could help
>
> We are configuring a 5500 Chassis with:
> > >
> > > 1) WS X5530 Supervisor Engine (Slot 1)
> > > 2) WS X5302 Route Switch Module (Slot 2)
> > > 3) WS 5224 Switch ports (24 copper ports)
> > >
> > > A)
> > > We have defined:
> > > VLAN 100 on 3/1-4
> > > VLAN 200 on 3/5-8
> > > VLAN 300 on 3/9-12
> > > VLAN 500 on 3/21-24
> > > B)
> > > We have created the interfaces on the RSM:
> > > Config Terminal:
> > > 1) Interface vlan 100
> > > ip address 192.170.1.1 255.255.255.0
> > > 2) Interface vlan 200
> > > ip address 192.170.2.1 255.255.255.0
> > > 3) Interface vlan 300
> > > ip address 192.170.3.1 255.255.255.0
> > > 5) Interface vlan 500
> > > ip address 192.170.5.1 255.255.255.0
> > >
> > > Performed a no shutdown command on all interfaces.
> > >
> > > C)
> > > We implemented "eigrp 1" as the routing protocol using:
> > > Interface vlan 100
> > > router eigrp 1
> > > network 192.170.1.0
> > > network 192.170.2.0
> > > network 192.170.3.0
> > > network 192.170.5.0
> > > The above was repeated for all vlans (100,200,300,500)
> > > D)
> > > 1) Can not ping any vlan interfaces.
> > > 2) Performed a "Show Interface" and it shows all interfaces are down.
> > >
> > >
> > > Thanks for looking into this and we appreciate any insight on this
> > > problem.
> > >
> > Craig.
>
>
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
