Want to get to setup frame relay on my two routers connectected (2x 2501)
back-to-back with a DTE/DCE cables. When both routers boot up I could see
the routing table with "sh ip route" and after 30 secondes the protocol on
the serial interfaces go down. Can you help
Here is the sample config:
Router1:
interface Serial0
clockrate 64000
bandwidth 64
ip address 10.0.2.5 255.255.255.252
no ip directed-broadcast
encapsulation frame-relay
frame-relay lmi-type cisco
frame-relay interface-dlci 100
Router2:
interface Serial0
bandwidth 64
ip address 10.0.2.6 255.255.255.252
no ip directed-broadcast
encapsulation frame-relay
frame-relay lmi-type cisco
frame-relay interface-dlci 200
_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]