Add the no keepalive commands to both your interfaces. Check out the
links below.
Back-to-Back Frame Relay
http://www.cisco.com/warp/public/125/frbacktoback.html
Technical tips for Frame Relay http://www.cisco.com/warp/public/125/
mindiani mindiani wrote:
>
> Want to get to setup frame relay on my two routers connectected (2x 2501)
> back-to-back with a DTE/DCE cables. When both routers boot up I could see
> the routing table with "sh ip route" and after 30 secondes the protocol on
> the serial interfaces go down. Can you help
>
> Here is the sample config:
>
> Router1:
>
> interface Serial0
> clockrate 64000
> bandwidth 64
> ip address 10.0.2.5 255.255.255.252
> no ip directed-broadcast
> encapsulation frame-relay
> frame-relay lmi-type cisco
> frame-relay interface-dlci 100
>
> Router2:
>
> interface Serial0
> bandwidth 64
> ip address 10.0.2.6 255.255.255.252
> no ip directed-broadcast
> encapsulation frame-relay
> frame-relay lmi-type cisco
> frame-relay interface-dlci 200
>
> _________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
>
> _________________________________
> FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
--
----------------
Shabbir S. Talib
MCSE, CNE, CCNA
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
