I'm trying to interconnect two Cisco 3600 routers through a Frame Relay private line for voice traffic. I have a FXS card at one end and a FXO card+PBX on the the other. FXS card phones are supossed to make calls to ext.5105/5106 (pbx) This is the configuration on the FXS side: voice-port 1/0/0 voice-port 1/0/1 ! dial-peer voice 3 pots destination-pattern 5141 port 1/0/0 ! dial-peer voice 4 pots destination-pattern 5142 port 1/0/1 ! dial-peer voice 6 vofr destination-pattern 510. session target Serial0/0 700 codec g726r16 ! interface Serial0/0 ip address 192.1.1.1 255.255.255.0 encapsulation frame-relay IETF frame-relay lmi-type ansi frame-relay interface-dlci 700 class CALLCENTER vofr data 4 call-control 5 ! map-class frame-relay CALLCENTER frame-relay adaptive-shaping becn frame-relay cir out 64000 frame-relay bc out 1000 frame-relay voice bandwidth 40000 This is the configuration on the FXO side: voice-port 1/0/0 voice-port 1/0/1 ! dial-peer voice 3 pots destination-pattern 5105 port 1/0/0 ! dial-peer voice 4 pots destination-pattern 5106 port 1/0/1 ! dial-peer voice 6 vofr destination-pattern 510. session target Serial0/0 700 codec g726r16 ! interface Serial0/0 ip address 192.1.1.1 255.255.255.0 encapsulation frame-relay IETF frame-relay lmi-type ansi frame-relay interface-dlci 700 class CALLCENTER vofr data 4 call-control 5 ! map-class frame-relay CALLCENTER frame-relay adaptive-shaping becn frame-relay cir out 64000 frame-relay bc out 1000 frame-relay voice bandwidth 40000 Nuances: ***Voice ports have default settings ***I created DLCI 700 on the frame-relay switches with CIDs 4&5 (PVC status are OK on both ends) ***I get dial tone on the FXS ports, but when I dial the extension number....just dead air!!! Any suggestions?? Thanks in advance Roberto Luesma _________________________________ FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
