I've already done that, but when I do sho run on the DCE router it doesn't
show the clock rate in the config.....whats going on?
"John Neiberger" <[EMAIL PROTECTED]> wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> I believe the cause of your problem is that you are using the bandwidth
> statement instead of the clock rate statement. The bandwidth statement
has
> no effect on physical layer clocking, it only makes adjustments to routing
> protocol metric calculations.
>
> To make this behave correctly, add "clockrate 64000" to the DCE side. If
> that doesn't work, let us know.
>
> HTH,
> John
>
> > I can't seem to bring up the protocol on my 2 routers. A 2503 (DTE)
and
> a
> > 1005(DCE w/ clockrate of 64000) connected via crossover serial. Here
are
> the
> > serial interfaces configs..
> >
> > Cisco 1005
> > interface Serail0
> > ip address 192.0.0.2 255.255.255.0
> > encap ppp
> > bandwidth 64
> >
> >
> >
> > Cisco 2503
> > interface Serial0
> > ip address 192.0.0.1 255.255.255.0
> > encap ppp
> > bandwidth 64
> >
> >
> >
> > _________________________________
> > FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
>
>
>
>
> _______________________________________________________
> Send a cool gift with your E-Card
> http://www.bluemountain.com/giftcenter/
>
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]