Your problem is the version/type of code that you are running. You will need
to download the full version of IOS from CCO. The version that you have is
an rxboot image. ROM uses this code to boot. I believe that if you can go in
and look at the flash you will see that the image is only about 1.5 meg
where a full IOS image would be at least 5 megs or larger. You will probably
have to use the TFTPDNLD command in ROM to upgrade to the new IOS code.
http://www.cisco.com/univercd/cc/td/doc/product/software/ios112/112cg_cr/1cb
ook/1csysim.htm#xtocid2402288
Hope that helps..
Tim
----- Original Message -----
From: "Steve Smith" <[EMAIL PROTECTED]>
To: "Roger Sohn" <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]>
Sent: Tuesday, February 20, 2001 9:37 AM
Subject: RE: Boot Problems on a 7200
Is the following statement in your config? boot system flash
slot0:c7200-boot-mz.120-10.S.bin .I have seen that problem when the
statement is not in there.
regards,
Steve
-----Original Message-----
From: Roger Sohn [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, February 20, 2001 2:42 AM
To: [EMAIL PROTECTED]
Subject: Boot Problems on a 7200
I've tried searching massively through CCO and can't seem to find the
solution to this problem.
I have a Cisco 7206VXR and everytime I try to boot it up, everything is
dandy...but it always comes to the prompt of "Router(boot)". This is
the
output when I run a "show version". It says that the system is returned
to
ROM by reload. Is this tied in with the problem? I currently have it
set
to boot off the flash disk with the image of c7200-boot-mz.120-10.S. Am
I
missing something?
-Roger
---
Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (C7200-BOOT-M), Version 12.0(10)S, EARLY
DEPLOYMENT
RELEA
SE SOFTWARE (fc1)
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Fri 24-Mar-00 15:54 by htseng
Image text-base: 0x60008900, data-base: 0x60684000
ROM: System Bootstrap, Version 12.0(19990210:195103) [12.0XE 105],
DEVELOPMENT S
OFTWARE
California uptime is 4 minutes
System returned to ROM by reload
System image file is "disk0:c7200-boot-mz.120-10.S"
cisco 7206VXR (NPE300) processor with 57344K/40960K bytes of memory.
R7000 CPU at 262Mhz, Implementation 39, Rev 2.1, 256KB L2, 2048KB L3
Cache
6 slot VXR midplane, Version 2.0
Last reset from power-on
Bridging software.
X.25 software, Version 3.0.0.
3 FastEthernet/IEEE 802.3 interface(s)
8 Serial network interface(s)
Router(boot)#
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
