hmmmm, I have 2 BEFSR41s (one for adsl and one for cable) and all port
forwarding works ok also.
You say that you can remotely access an NT server..... I take it that is by
Telnet?
So, then you also try to telnet the router? I'm wondering if you're allowed
to have a single port (port 23) forwarded to different inside
addresses......... which is what it sounds like you're trying to do.
Define only one end address for port 23 (the router) and try that.
For all my port forwarding I have only one destination for each defined
port/range.
Kevin Wigle
----- Original Message -----
From: "Mark Rose" <[EMAIL PROTECTED]>
To: "Cisco@Groupstudy. Com (E-mail)" <[EMAIL PROTECTED]>
Sent: Monday, 05 March, 2001 12:28
Subject: Telnet to a Router
>
> I am trying to telnet to a 2514 router from work. I have a Linksys BEFSR41
> ethernet/dsl router on my incoming cable line. I have enabled port
> forwarding for telnet (port 23) on this router. I have also set up vty on
> the 2514. When I try to telnet to the wan interface of the Linksys
forwarded
> to the ethernet interface on the 2514 I get the message "Could not open a
> connection to host: Connection failed". But if I remote access an NT
server
> inside my home net (on internal address space), from there I can telnet
(on
> the private address space) to the same ethernet interface and connect.
>
> Since I can remote access my NT box, port forwarding on the Linksys router
> is working. Also the 2514 should be set properly since I can telnet in
from
> within my lan. I must be overlooking something but I cannot figure it out.
>
> I would appreciate any ideas or assistance.
>
> TIA
> Mark
>
>
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
