Well you can use the STATIC and CONDUIT commands to do it and open ports
with the conduit statement. However, these will be replaced with ACL
statements in a near future version. If you have a manual, see if you can
figure it out from there. If not I can help you offline & send the final
result back to the list.
----- Original Message -----
From: "Muhammad Faheem" <[EMAIL PROTECTED]>
To: "cisco@groupstudy. com (E-mail)" <[EMAIL PROTECTED]>
Sent: Tuesday, March 13, 2001 11:56 AM
Subject: How to Open Pix firewall Ports
> Hi Guys
>
> I want to open port 3050 and 3051 on Pix firewall , i would appreciate if
> any body Guide me how to get this done or what command should i check.
>
> Regards
> Muhammad Faheem
> Systems Engineer
> Afcomp
> Hello : (9714)-3933878 / 3027338
> Fax : (9714)-3933832
> Web : www.afcomp.com
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
