I have no idea why or what you have done (0x3920 :-) The only superior BREAK command I know is to lower Hyper Term to 1200 (reset the Hyper Term window) & power the router off/on. Hold the space bar for 5 seconds while powering the router on, you should see some garble in the top left of the screen (may have to do this a couple of times for it to take). This sends the manual BREAK signal that commands sometimes do not. Lastly- change everything back. Other than the above, call the TAC or pull the FLASH so it will only boot to ROM (then change your config values back to 0x2102 or o/r 0x42). Let us know how you make out !!! Phil ----- Original Message ----- From: "Stull, Cory" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Wednesday, March 14, 2001 11:03 PM Subject: 2523 > We've got a 2523 in the office that we changed the config-reg settings to > 0x3920 and it now won't let us into it at all... We've tried to ctrl-break > out during boot and its not helping... > > Any other suggestions? > > Thanks > > _________________________________ > FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED] _________________________________ FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]