Generally, a route will only be installed into the routing table if the
next-hop address is reachable. If you have static routes in the running
config, they will not show up until the line comes up.
HTH,
John
>>> "Morgan Hairston" <[EMAIL PROTECTED]> 3/16/01 11:29:27 AM >>>
I am configuring a 1600 router and don't have anything connected to
either
the s0 or e0 interfaces. I have defined a gateway of last resort and
3
static routes to network on other side of wan. When I use sh ip route,
I
don't get any routes listed at all. Not even those that should be
connected. If I sh run, its all there. I'm not certain, but suspect
that
since the lines are down, disconnected) this may have something to do
with
it. Thanks in advance.
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
