ATM interface troubleshooting question. [7:2249]

[[EMAIL PROTECTED] (Katson Yeung)]

Dear all,

My old 7507 is having a minor problem.... it is 12.0.16GD, RSP2 with
64M ram and the ATM card is an AIP. I have only one VC associate with
this ATM port.

I found quite a number of input errors (CRC and Frames)... how can I
know the source of that problem?? Is it the cell level, or the frame
level problem?


See below show interface output:


ATM0/0 is up, line protocol is up 
  Hardware is cxBus ATM
  MTU 4470 bytes, sub MTU 4470, BW 155520 Kbit, DLY 80 usec, rely
255/255, load 8/255
  Encapsulation ATM, loopback not set, keepalive not supported 
  Encapsulation(s): AAL5, PVC mode
  256 TX buffers, 256 RX buffers,
  2048 maximum active VCs, 1024 VCs per VP, 1 current VCCs
  VC idle disconnect time: 300 seconds
  Last input 00:00:00, output 00:00:00, output hang never
  Last clearing of "show interface" counters 3d10h
  Queueing strategy: fifo
  Output queue 0/40, 0 drops; input queue 1/75, 40 drops
  5 minute input rate 34782000 bits/sec, 4564 packets/sec
  5 minute output rate 5307000 bits/sec, 3372 packets/sec
     1174284787 packets input, 1013959162 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 11 throttles
     13076769 input errors, 13054514 CRC, 22255 frame, 0 overrun, 0
ignored, 0 abort
     893230791 packets output, 346650156 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets
     0 output buffer failures, 0 output buffers swapped out




Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=2249&t=2249
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]