Can a 2511 be setup to connect a cable modem (ethernet) to a network segment
(ethernet)? I was going to use a 4000 but I do not have the flash
requirements to run 12.1 code so that I can make use of the "ip address
dhcp". Can I use one of the Async ports to connect to the cable modem end
(provider via dhcp) and then enable nat to my network via the e0. Is this
possible? Has anyone tried this before?
Thanks
Confidentiality Notice: This e-mail message, including any attachments, is
for the sole use of the intended recipient(s) and may contain confidential
and privileged information. Any unauthorized review, use, disclosure or
distribution is prohibited. If you are not the intended recipient, please
contact the sender by reply e-mail and destroy all copies of the original
message.
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=2312&t=2312
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
