quick answer - no
The connection to the cable modem is ethernet. Don't get confused by the
term "modem".
You need a router with 2 ethernet ports.
Kevin Wigle
----- Original Message -----
From: Roberts, Timothy
To:
Sent: Friday, April 27, 2001 3:52 PM
Subject: 2511 between cable modem and network [7:2312]
> Can a 2511 be setup to connect a cable modem (ethernet) to a network
segment
> (ethernet)? I was going to use a 4000 but I do not have the flash
> requirements to run 12.1 code so that I can make use of the "ip address
> dhcp". Can I use one of the Async ports to connect to the cable modem end
> (provider via dhcp) and then enable nat to my network via the e0. Is this
> possible? Has anyone tried this before?
> Thanks
>
> Confidentiality Notice: This e-mail message, including any attachments, is
> for the sole use of the intended recipient(s) and may contain confidential
> and privileged information. Any unauthorized review, use, disclosure or
> distribution is prohibited. If you are not the intended recipient, please
> contact the sender by reply e-mail and destroy all copies of the original
> message.
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=2315&t=2312
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
