If you use the following to upload the IOS into your router.
TFTP, FTP, RCP.
I do not see any problem.
Note: For IOS file greater than 16M, you can't use TFTP.
TIA
Vincent
""Sean C."" Hi Group,
>
> I'm uploading a new IOS on a 2509. I've verified I have enough Ram/Flash
on
> the 2509 for the new IOS. I have to use the available memory pumping the
> new IOS on, so I'm going to have to squeeze the old IOS off before doing
the
> new upload.
>
> To do the upload, can I go through the AUI interface, via a transceiver,
and
> use a cross-over cable attached right to the Ethernet port on my PC
> (assuming I use proper IP addresses)?
>
> I've done this a few times on 2600's (doing a cross-over between the 2600
> Ether and my PC) but have never put a transceiver into the mix.
>
> TIA,
> Sean C.
>
> CCNP, CCDP, MCSE
> Email: [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=6711&t=6687
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
