If you are connecting to a non-Cisco device you need to set the frame
relay encapsulation type to ietf and the LMI type to ANSI. The defaults
are cisco encapsulation type and cisco LMI, neither of which will that
device understand. Try that change and let's see if that resolves the
issue. If not, please let us know.
HTH,
John
>>> "Khurrum Shahzad" 6/12/01 12:13:49 PM >>>
When connecting cisco router ( as frame-relay switch) with frame relay
device, I configured frame relay route as
Serial 0 Dlci in 16 to Serial 1 Dlci out 26
Serial 1 Dlci in 27 to Serial 0 Dlci out 17
( require only these 2 routes)
But "show frame-relay pvc" shows both route status inactive and both
route
does not work.
When I give additional two route ( not required )
Serial 1 Dlci in 26 to Serial 1 Dlci out 16
Serial 0 Dlci in 17 to Serial 0 Dlci out 27
then both route status become active and configuration works.
Is it necessary that dlci path must be completed?Because sometime it is
not
required to complete path of dlci.
Can anybody give me guidence on this topic ?
--
_______________________________________________
Get your free email from http://mymail.iname.com
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=8231&t=8217
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
