Hi John,
When you set up your frame relay network you have to be sure to give your
interface a dlci and tell it where to go...like you have below...s0 use dlci
16 to the frame cloud which uses dlci 26 to get to s1. But then you have to
tell s1 that it needs to use dlci 26 to get back to the frame cloud which
uses dlci 16 to get back to s0. What you have is serial 1 send down dlci 27
to the frame cloud and forward down s0 on dlci 17. If you do an show frame
pvc on the routers attached on s1 and s0 you will see that one has dlci 16
assigned and the other has dlci 27 assigned. But the frame is trying to
send data to them on dlci 26 and dlci 17 which they dont know about.
so you just need to make sure that your dlci's match and that are an inverse
of each other.
Here is the output from my current lab:
c4500#sh frame route
Input Intf Input Dlci Output Intf Output Dlci Status
Serial1 102 Serial3 201 active
Serial2 103 Serial3 301 active
Serial3 201 Serial1 102 active
Serial3 301 Serial2 103 active
good luck,
Don
-----Original Message-----
From: John Neiberger [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, June 12, 2001 1:02 PM
To: [EMAIL PROTECTED]
Subject: Re: frame-relay route question [7:8217]
If you are connecting to a non-Cisco device you need to set the frame
relay encapsulation type to ietf and the LMI type to ANSI. The defaults
are cisco encapsulation type and cisco LMI, neither of which will that
device understand. Try that change and let's see if that resolves the
issue. If not, please let us know.
HTH,
John
>>> "Khurrum Shahzad" 6/12/01 12:13:49 PM >>>
When connecting cisco router ( as frame-relay switch) with frame relay
device, I configured frame relay route as
Serial 0 Dlci in 16 to Serial 1 Dlci out 26
Serial 1 Dlci in 27 to Serial 0 Dlci out 17
( require only these 2 routes)
But "show frame-relay pvc" shows both route status inactive and both
route
does not work.
When I give additional two route ( not required )
Serial 1 Dlci in 26 to Serial 1 Dlci out 16
Serial 0 Dlci in 17 to Serial 0 Dlci out 27
then both route status become active and configuration works.
Is it necessary that dlci path must be completed?Because sometime it is
not
required to complete path of dlci.
Can anybody give me guidence on this topic ?
--
_______________________________________________
Get your free email from http://mymail.iname.com
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=8244&t=8217
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]