[ The following text is in the "x-user-defined" character set. ]
[ Your display is set for the "US-ASCII" character set. ]
[ Some characters may be displayed incorrectly. ]
I have just bought a Cisco 2503 router from Ebay. However, after I boot
up the router, I only see the following 2 interfaces:
Router>show ip int brief
Interface IP-Address OK? Method Status
Protocol
BRI0 unassigned YES not set administratively down
down
Ethernet0 unassigned YES not set administratively down
down
Router>
But I can't find the Serial interfaces. I tried swapping out the DRAM
and Flash, but the same thing happen. Please help. Another thing I
noticed when the router boots up:
F3: 3343908+79112+202788 at 0x3000060 show flash
System flash directory:
File Length Name/status
1 3423052 igs-g-l.110-9
[3423116 bytes used, 771188 available, 4194304 total]
4096K bytes of processor board System flash (Read ONLY)
And when i do show ver, it's not even showing up??
Processor board ID 02996147, with hardware revision 00000000
Bridging software.
Basic Rate ISDN software, Version 1.0.
1 Ethernet/IEEE 802.3 interface.
1 ISDN Basic Rate interface.
32K bytes of non-volatile configuration memory.
4096K bytes of processor board System flash (Read ONLY)
Configuration register is 0x2102
Regards,
Hunt Lee
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=9311&t=9311
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]