I think the only way to get in to puppy is to set it up for autoinstall.
See link:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios112/112cg_cr/1cb
ook/1cclkstr.htm
Tony M.
#6172
----- Original Message -----
From: EA Louie
To:
Sent: Saturday, June 23, 2001 2:11 AM
Subject: Dead console port [7:9621]
> Okay gang, here's a challenge that I'm trying to overcome (warning: it
may
> not be solvable)
>
> I just got a 2514 where I couldn't get any response from the console port.
> Of course, I tried changing baud rates, etc, but when I finally connected
to
> the AUX port, I was able to get in. The enable password was cisco, so I
> gleefully got into the config and changed the config register, hoping that
> would solve the problem. It didn't, so I did the next (very stupid)
thing -
> I erased the config (I'm beating my head against the desk as I type).
Now,
> of course, the problem is when I go to the AUX port and try to get into
> enable mode, I can't ("no password set").
>
> Is there any way for me to "bypass" the console port by using the AUX
port,
> or have I just rendered this device useless until I find a way to fix the
> console port? I don't think I can get into ROMMON mode from the AUX port,
> and I can't get into priveleged EXEC mode, either.
>
> TIA,
> -e-
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=9630&t=9621
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
