I believe it is a pretty simple setup. You just put an IP on the box through
serial then telnet into it and it is menu driven from there. Go to config
menu and name a port say 47xxMM then physically connect that port to the
console port of the 47xx series with the mm card.
Then telnet into the xyplex box, either type in or select the port you want
and it will take you to the console. I don't think you even have to name the
ports that is just done so you can keep it straight.
I believe the model was a 1608M that was an 8 port model with a built in
modem for out-of-band access in case your network goes down and you have to
get in, in the first place to bring the network back up. But since reverse
telnet is supposedly going away that is an excellent box for the job. I
still got to get up a change cables for mine.
----- Original Message -----
From: "Louie Flores"
To:
Sent: Wednesday, August 01, 2001 8:38 AM
Subject: Xyplex 1600 as Terminal server For my Routers [7:14504]
> I was using an IBM 3250 as a terminal server to my practice lab - I
upgraded
> to a 16 port xyplex 1600 maxserver. Is anyone else using this in the same
> capacity? I could really use a config for it- I have the mx1500.sys
> software running on it from tftp and have played a little with it but
> haven't figured out configuring services etc.
>
> Any config, wwether reverse telnet to the ports or telnet in and CONNECT
to
> port x, I don't care - just something that will save me 2 weeks of trial
and
> error would be great
>
> Thanks
> Louie
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=14516&t=14504
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
