I did call the telco since I'm the owner by inheritance and was concerned
when I saw this. Apparently it's not a problem, I just never seen it before.
----- Original Message -----
From: "Brian"
To: "Mike Mandulak" ;
Sent: Wednesday, August 08, 2001 9:49 AM
Subject: Re: DE bits [7:15210]
> I doubt the cir is set to zero, it almost certainly is set to a value
below
> the 1.5 meg value, I'd suspect 768k perhaps. Whomever is the circuit
owner
> can call the telco to find out.
>
> Brian
>
> ----- Original Message -----
> From: "Mike Mandulak"
> To:
> Sent: Tuesday, August 07, 2001 9:16 PM
> Subject: DE bits [7:15210]
>
>
> > Do discard Eligible bits (DE) get set on lines that are full T1's? The
> > circuit I'm looking at is a full T1 to one of my internet providers and
> when
> > looking at the frame stats (using cisco LMI) I see that that the cir is
> set
> > to zero which would mean that all frames leave my site with the DE bit
> set.
> > Am I misunderstanding this?
> >
> > MikeM
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=15386&t=15210
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
