Make sure you are using a crossover cable if you are going directly
between the two ethernet ports.
Symon
-------------------
> I am somewhat new to Cisco and routers. I purchased the Sybex CCNA
by todd
> lammle and I have to say it doesn't go into detail as to where to
hook up
> the
> cables and which end is going where etc etc.
>
> I basically have two 2501 routers ....on RouterA I have a DTE end
connected
> to serial 0 and on RouterB I have the same cable but with the end
labeled
> DCE
> running striaght into serial 0. This as far as I found is the way
it should
> be connected.
>
> Now my question is this, for the ethernet port I have two LanCast
> Transceivers I put one transceiver on one router...and the other
transceiver
> on the other router. I have a RJ45 cable running from RouterA to
RouterB
> ....is this the way its suppose to be? If so for some reason I'm
unable to
> get the ethernet port to work....and its causing much confusion. IS
the
> ethernet port for LAN only and the serial ports for WAN...is this
how Cisco
> set this up??
>
> Thank you for reading through this lengthy e-mail and I awaite for
your
> responses.
[EMAIL PROTECTED]
>
Cheers,
Symon
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=17637&t=17633
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
