That's what I thought. Is this because the main interface needs to be
bridging? If not, what is the reasoning behind this?
Thanks,
Sean
""Baker, Jason"" wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> yes there is amjor flaw in your config.
>
> if you are using vlans which means subinterfaces, if you put an IP address
> on the main interface
> it will not work.
>
> so remove the ip address on interface 1/0 and you should be fine.
>
>
>
> > -----Original Message-----
> > From: Sean Knox [SMTP:[EMAIL PROTECTED]]
> > Sent: Thursday, 6 September 2001 7:39 am
> > To: [EMAIL PROTECTED]
> > Subject: VLAN configuration question [7:18696]
> >
> > On a Cisco router/switch running IOS with VLAN capabilities (i.e. 8500)
> > can
> > a physical interface have an IP address if a subinterface off the same
> > physical interface has an IP and is actively participating in a VLAN?
i.e.
> >
> > Router(enable)# conf t
> > Router(config)# interface 1/0
> > Router(config-if)# ip addr 10.10.10.50 255.255.255.0
> > Router(config-if)# interface 1/0.1
> > Router(config-if)# ip address 10.10.10.1 255.255.255.0
> > Router(config-if)# encapsulation dot1q 15
> >
> > Are there any problems forthcoming in this setup? I seem to remember
there
> > was, but I have no equipment to verify this.
> >
> > Thanks!
> > Sean
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=18710&t=18696
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
